![cat sis installation cat sis installation](https://www.autoepccatalog.com/wp-content/uploads/2019/07/2019-Caterpillar-SIS-CAT-SIS-Software-Download-Installation-Service-4-300x224.jpg)
Of 102.00 to 102.04 mm (4.016 to 4.017 inch).Ī cylinder head gasket is used between the plate and the head in order to seal combustion gases, water, and oil.Įngine has a cast cylinder head. Bore the sleeve and hone the sleeve to a diameter
#Cat sis installation install
Install the cylinder sleeve in the bore of the block with theĪppropriate tooling. Remove the remainder of the cylinder sleeve with a hammer and Bore the cylinder sleeve to 0.5 mm (0.02 inch) of the original Set up a boring bar on the cylinderīlock. Replace the cylinder sleeve if a sleeve is worn or if a sleeve is worn Thrust bearings on the main bearing journals control the end play of theĪ cylinder sleeve is available as a replacement. TheĬrankshaft of the four cylinder engine has five main bearings and theĬrankshaft of the six cylinder engine has seven main bearings. The spacer between the valve stem and the rocker arm.ģ0 Engines for Caterpillar Built MachinesĬylinder Block, Cylinder Liners, and Cylinder Head The cylinder block has cylinders which are arranged in-line. The crankshaft by 1/8 of a turn in a counterclockwise direction.
![cat sis installation cat sis installation](https://i0.wp.com/www.solomecanicos.com/wp-content/uploads/2020/07/SIS-CATERPILLAR-2021-7.png)
That is approximately 5 mm (0.2 inch) thick between the valve stem and Insert a suitable lever between the rocker arm and the valve
![cat sis installation cat sis installation](https://cdn.shopify.com/s/files/1/0330/9902/2475/products/caterpillar-sis-2015-3d-cat-et-2015a-cbt-stwdownload-D_NQ_NP_924401-MLB20316445053_062015-F-1080x600_14bd23c5-7d9e-434b-bf94-523c2fc3fd3a_1024x1024.jpg)
Rotate the crankshaft further by 1/8 of a turn in a clockwiseĭirection.Rotate the crankshaft until the pushrod for the inlet valve Rotate the crankshaft clockwise when you face the front of.Use Tooling (A) in order to rotate the engine.